Happy long weekend! I hope there are crafty plans in place. 🙂 Kelly’s here to jumpstart your weekend with a gorgeous project using our new Reflections set…
Hello and welcome to this week’s TGIF feature! It’s Kelly here today sharing a fun shaped tri-fold design with a belly band! I’m enamored with the new Reflections stamp/die set and couldn’t wait to try using it for this tri-fold design! It was easy to put together, but DID require a little planning. I’m hoping that I can walk you through step-by-step easily so you can try your own!
[imagelinks id=”291″]
To begin, I cut two panels from white cardstock measuring 4 ¼ by 5 ½ inches and then die cut the outline using the new Reflections die. I die cut one a little further down on the panel and one up a little bit higher so that when the card is assembled, it gives the realistic illusion of a forest. Once the two panels were cut, I went ahead and stamped both panels using assorted Distress Oxide inks. As you can see on the panel on the right, I varied the shore line to keep it visually interesting.
Once that was done, I was able to get the base for my tri-fold design put together. I cut a piece of Kraft cardstock measuring 5 ½ by 11. The two panels that fold in measure 3 ½ inches, but I ended up cutting them as I will explain in the next steps, but you’ll want to begin with these measurements. I placed the first panel on the left fold butted right up against the bottom and corner and then carefully placed the die directly around the trees, and secured it with washi tape. Once it was secure, I removed the stamped portion and ran it through my die cut machine. You’ll repeat this for the second flap, but you’ll need to leave it hanging off the edge of your die cut machine so it doesn’t cut through the back of the card. It might seem confusing reading it, but when you go to make your card, you’ll understand!
I used an Exacto Knife and a ruler to remove the pieces that I didn’t need along the fold. From there, I went ahead and glued the two stamped panels in place, using the die cut portion of the Kraft base as my guide. From there, you will see that you have pieces hanging over the edge that will need to be cut straight with your paper trimmer. Once I had it all squared up, I got to work on the inside!
I die cut the middle size of the Crimped Frames and added some blue ink blending around the edges for a sky. I stamped the sentiment, which is from the Sentiment Suite: Thinking of You stamp set, directly onto the panel. The smaller sentiment at the top AND the sentiment for the belly band are from the same set. I used the Sentiment Suite: Basics die for the little banner piece at the top. The belly band is just a strip of the same Kraft cardstock with the sentiment stamped in the middle and then scored slightly larger than the width of the card so it can easily slide off and on.
I finished off the card by adding some watercolor details to the trees, sand, and water. While I don’t enjoy needing Sympathy cards, I do like having a few on hand. I really like this particular stamp set for a sympathy card because flowers, etc. aren’t always the perfect choice, even if we want them to be (wink!). Thanks for joining me today and I hope you get a chance to try your own shaped tri-fold design!
